ALcom AT-5928, User Manual

Page: 9 / 11

ONE TOUCH MEMORY OPERATION
 Store the number in one-touch memory
1. Pre-dial the desired number or checking incoming and outgoing number that you want to
store.
2.
Press ST/RECALL key
3.
Press M1 or M2 or M3 key
 Make a call from one-touch memory
In off-hook or on-hook situations, press M1 or M2 or M3 key to dial the stored number out.
TWO TOUCH MEMORY OPERATION
 Store the number in two-touch memory
1. Pre-dial the desired number or checking incoming and outgoing number that you want to
store.
2.
Press ST/RECALL key
3.
Press one of digit key (0-9)
 Make a call from two-touch memory
In off-hook or at hands-free state, press ST/RECALL key + digit key (0-9) key, the relevant
number will be dialed out.
LOW BATTERY DETECTION
When the voltage is lower than 3.9v, LCD displays “  ” icon to remind the user to replace the
batteries.
LCD BACKLIGHT FUNCTION
The backlight is turned on when receiving an incoming call, dialing, pressing any key or in
MUSIC HOLD mode. It will fade off if the telephone is left idle for 10 seconds.
NOTE: If batteries are not installed or DC adaptor is not inserted, there will be no LCD
backlight function.
FLASH FUNCTION
When dialing and the line is engaged, press FLASH/÷ key and then press REDIAL key to dial it
out again.
LOCK
Turn the key to yellow point, all numbers are locked except emergency numbers 119, 120, 122,
110.
Turn the key to green point, all numbers starting with “0” are locked
Turn the key to red point, all numbers are allowed to be dialed out .
KEY TONE
1.
In on-hook state, press and hold CAL key 3 seconds, key tone is active when hearing “di”
voice.
2.
Press and hold CAL key 3 seconds again, key tone is inactive when hearing “di” voice.
9