Alcoa BTT20SF, Assembly Manual

Page: 5 / 38

5
Hydraulic Manifold for the
BTT20SF tool.
Now the Hydraulic hoses can
be screwed into the manifold
using a hydraulic loctite thread
sealer and tightened down.
Slide the handle over the
hydraulic quick disconnects and
up the hoses to the manifold.
Then insert the lemo wire
through the strain relief which is
attached to the alum. Base
plate and feed the wires up
through the handle and attach
the alum. Base plate using two
#10-24x1/2” long BHCS.
CV plugs (CVES2503231A Dia.
.250” short) are put into the
manifold first using a hammer
and the installation tool
Then a 1/16x5/16 socket
pressure plug (3/4 taper) with
blue loctite is screwed into the
manifold.
Installation tool
(CVTS060) required by the CV
manufacture.
Handle Assembly (cont’d)