Removing and Adding Modules
Network Interface (NI) Modules
page 5-32
OmniSwitch 8800 Hardware Users Guide
December 2004
Adding a Module
To install a CMM or NI module, follow the steps below. (To remove an SFM, see
).
Important.
Before beginning, note that the CMM modules and NI modules slide into the chassis card
guides differently. With CMMs, the back of the module’s printed circuit board (which is wider than the
front side) initially provides the glide path. When the printed circuit board narrows a sheet metal flange
continues the remaining glide path. With NIs, the edges of the module’s printed circuit slide into the
guides.
1
Holding the module in both hands, carefully slide it into the chassis card guide. The component side of
the board should face right.
2
The module should slide in easily. Do not force the module into the slot. If any resistance is encoun-
tered, ensure the module is aligned properly in the card guide. Also, see the important note regarding chas-
sis card guides on
