65
Installation Guide: 601, 602, and 604 Routers
MIBs
Alcatel systems support standard and enterprise MIBs. The following tables provide
information about supported MIBs.
Table 28 Standard MIBS
Standard MIB
Description
RFC 1213
Standard MIB-II objects.
The following groups or variables are not supported for this MIB:
n
egp
n
at
RFC 1315
MIB objects for frame relay DTE interface.
The following SNMP SET operation variables on frDlcmiTable are not supported for this MIB:
n
frDlcmiAddress
n
frDlcmiAddrsssLen
n
frDlcmiMaxSupportedVCs
n
frDlcmiMulticast
RFC 1403
Defines the interoperability of using BGP as the border gateway routing protocol and OSPF as
the interior gateway routing protocol.
RFC 1406
MIB objects for DS1 interface.
The following Far End tables are not supported for this MIB:
n
dsx1FarEndCurrentTable
n
dsx1FarEndIntervalTable
n
dsx1FarEndTotalTable
RFC 1643
MIB objects for Ethernet-like interface.
The following variables are supported for this MIB:
n
dot3StatsFCSErrors
n
dot3StatsDeferredTransmissions
n
dot3StatsFrameTooLongs
The remainder are not supported.
RFC 1657
Describes MIB objects used for BGP4 routing protocol.
RFC 1724
Describes MIB objects used for RIP routing protocol.
RFC 1850
Describes MIB objects used for OSPF routing protocol.
RFC 1997
Facilitates and simplifies the control of routing information. This rfc suggests a grouping of
destinations so that the routing decision can also be based on the identity of a group.
RFC 2096
Describes objects used for the display of CIDR multipath IP routes.
RFC 2233
MIB objects for interface table extensions including StackTable and ifXTable. IfStackTable
shows the sub-layer relationships of interfaces.
The following groups or variables are not supported for this MIB3:
n
ifTestTable
n
ifRcvAddressTable
n
In the ifXTable, all High Counters (HC)(ifHC***) variables requiring 64-bit counters are
not supported.
RFC 2787
Describes MIB objects used for managing Virtual Redundancy Protocol (VRRP) routers.