Alcatel MainStreet 2902, Manual

Page: 46 / 344

4 — Ground and power connections
4-6 2902 MainStreet Technical Practices
90-2906-01 May 2002
4.4 Startup diagnostics
At power-up, the unit goes through a startup sequence that includes a number of
startup diagnostic tests (or self-tests). The startup sequence should last for less than
1 minute. Figures 4-5 and 4-6 show the location of the LEDs. When the
2902 MainStreet unit is powered up without any LIMs or data interface modules
installed, the LEDs light up as described in Tables 4-1 and 4-2.
Once the startup sequence is finished, the LED indications depend on the node
configuration. See chapter 24 in
Maintenance
for descriptions of the visual indicators
or if the indicators do not light in the pattern described.
Once the diagnostic tests have run successfully, you are ready to initiate a node
management session, as described in chapter 10 in
Configuration
.
Figure 4-5 Front panel self-test indicators
Figure 4-6 Rear panel self-test indicators
Note —
Wait until the diagnostic tests are completed before
attempting to rectify a problem.
8831
Power
Event Status
System Status
Processor
Out of Sync 1
Out of Sync 2
2902 MainStreet
Network Termination Unit
Power
Event Status
System Status
Processor
Out of Sync 1
Out of Sync 2
8832
Line-1
Slot 2
Slot 1
Line-2 Modem Terminal Rx-1 Tx-1 Rx-2 Tx-2
P1 P2
Alarm
Display
O
I
Loop
Status
2 1 U
Status
Loop
Display
2 1 U
EDG Sig/Gnd