8262 DECT Handset
8AL90323ENAAed01
13 /
60
2.2 Installing the memory card
The handset SD card stores handset configuration data
The Bluetooth settings are not saved on the SD card.
If memory is removed, the handset will keep registration but the phone configuration and storage content
will revert to what they were before the memory card was inserted. If the memory card is placed in a new
8262 DECT Handset, the phone will use all user settings and storage content from the memory card but the
new phone must still be registered.
You must be in possession of the memory card for your phone.
The supported SD memory cards are:
Kingston 2, 4, 8 & 16 GB
– Class 4 & 10.
Transcend 2, 4, 8 & 16 GB
– Class 4 & 10.
Switch off the handset (long press).
Unlock the cover.
Lift up the cover.
Remove the battery from its compartment. You can turn your set over on
your hand to extract the battery from its compartment.
Be careful not to drop the battery.
Slide in the memory card from under the two small crescents and press it
as shown in figure.
Position the battery 'connectors ' side as shown in the drawing (A).
Terminate the installation of the battery in its compartment by pressing as
shown in the drawing (B).
Replace the cover.
Make sure that the lock is correctly positioned.
Switch on the handset (long press).
A
A
B
B
