Alcatel-Lucent 7950 XRS Series, Configuration Manual

Page: 339 / 502

System Management
7950 SR OS Basic System Configuration Guide Page 339
For example, system-name parameter ALA-1 for the name command configures the device name as ALA-1.
ABC>config>system# name "ALA-1"
ALA-1>config>system#
Only one system name can be configured. If multiple system names are configured, the last one encountered
overwrites the previous entry.
The no form of the command reverts to the default value.
Default The default system name is set to the chassis serial number which is read from the backplane EEPROM.
Parameters system-name — Enter the system name as a character string. The string may be up to 32 characters long.
Any printable, seven-bit ASCII characters can be used within the string. If the string contains special
characters (#, $, spaces, etc.), the entire string must be enclosed within double quotes.
system-ip-load-balancing
Syntax system-ip-load-balancing
no system-ip-load-balancing
Context config>system
Description This command enables the use of the system IP address in the ECMP hash algorithm to add a per system
variable. This can help guard against cases where multiple routers, in series, will end up hashing traffic to
the same ECMP/LAG path.
This command is set at a system wide basis.
The no form of the command resets the system wide algorithm to default.
Default no system-ip-load-balancing
switchover-exec
Syntax switchover-exec file-url
no switchover-exec
Context config>system
Description This command specifies the location and name of the CLI script file executed following a redundancy
switchover from the previously active CPM card. A switchover can happen because of a fatal failure or by
manual action.
The CLI script file can contain commands for environment settings, debug (excluding mirroring settings),
and other commands not maintained by the configuration redundancy.
The following commands are not supported in the switchover-exec file: clear, configure, candidate, oam,
tools, oam, ping, traceroute, mstat, mtrace and mrinfo.
When the file-url parameter is not specified, no CLI script file is executed.
Default
none