Press
the arrow up once and you will then see the screenshot that enables you to
select the “Table Channel frequency” for the
input/output
frequency.
Then press the down arrow
twice that will take you to screen you see the below which
requires you to enter the output frequency of the carrier you are processing without the offset.
You increase/decrease the values using the arrows
or use the numeric keypad to
enter the frequency. Ensure if you enter the value using the numeric keypad you use the
decimal point. The Australian Analogue/Digital frequency table can be seen on the next page .
NB. The PC-series allows you to set the output frequency as processor (e.g. If Input
Frequency is 177.500 MHz then Output frequency 177.500MHz) or converter (e.g. If
Input Frequency is 177.500 MHz then output frequency is 620.500MHz) as they are fully
agile.
