Use
Tune/OK
to key in the network key. Turning
the knob left and right will change the numbers,
characters and symbols that you wish to show in the
center of upper line of the screen. In this example, the
‘5’ is the current active number, to select it press
Tune/OK
once. Turning the knob counter clockwise
or right will shift the ‘character’ to the center of the
screen for selection and pressing the knob will select
it. Use the Back button to delete a selected character.
Once the Network Key has been completed, next press and hold
Tune/OK
to confirm the network key.
Now the product should try to access the Access point that you
have selected
Once the product managed to connect to the AP it
will now put a star next to the network AP SSID
name that you have selected. Press
Tune/OK
and
save the profile. So that the future connection to this
Wi-Fi AP you don’t have to go through the Wi-Fi AP
selection process again, if you are using the same
Wi-Fi AP for Internet Radio or Media Streaming
Once you select to save the profile, it will prompt
where to save as shown. Use
Tune/OK
to select
Yes or No.
Now your Wi-Fi AP connection setup is completed.
5
Remark for troubleshooting:
When the device connects with the AP and can’t
get IP address from DHCP server automatically, it will prompt an error
message as
IP 0.0.0.0.
Please check whether router's DHCP service is enabled or not, and try to
connect with the AP again. In company networks it can often happen, that the
network administrator does not provide any DHCP service. In such cases you
can enter the local IP address manually together with Subnet mask, Gateway
and DNS address.(You may ask network administrator for these numbers).
For example: IP Address: 192.168. 0.15 Subnet Mask : 255.255.255.0 ,
Gateway & DNS 192.168.0.1 (everything depends on LAN settings by