Annex to user manual BPA 100 (Navi Version)
For use as audio adapter for
navigation sets
the additional cable set mentioned in the user manual will not be used (these parts are also not supplied with this special
version). Please insert the BPA 100 plug directly into the audio output socket of the navigation set. Adjust the volume of the navigation set to not more than a medium value!
Useful Hints how to connect the BPA 100 with Bluetooth Motor Bike Helmets
Your BPA 100 comes already with our unique software, which allows pairing with all known Bluetooth Headset models under the pairing PIN codes 1234, 1111 or 0000 as
well. The PIN code is automatically adopted. Bluetooth Helmets or Helmet headsets like
ALBRECHT
,
BMW
,
MIDLAND
,
SCHUBERTH a
nd
VEMAR
have been successfully
tested
with the BPA 100 and can be paired like a cellular phone with BPA 100. The only difference is, that BPA 100 does not request any PIN code.
•
Switch off all items before starting the pairing procedure
.
You can check the BPA 100 by pressing the knob about 4 seconds. If it was on before, it will flash 4 x red to
show that it is now switched off. If it was off before, it will now flash 4 x green to show that it is on now. In that case please press again 4 seconds to make sure that it
is off now (4x red flashing).
•
Switch the helmet’s Bluetooth set into the pairing mode according to the helmet set’s user manual. Most Bluetooth sets show the pairing mode by fast flashing or dual
colour flashing of the control LED(s).
•
You reach the pairing mode of the
VEMAR
helmet by pressing the central knob for at least 10 seconds, until the LED starts flashing rapidly. Make sure that the
helmet was off before starting the procedure. You have now about 20 seconds time to start the pairing of BPA 100.
•
For the
BMW
helmet, follow the instructions on page 41 (pairing with a cellular phone) of the user manual. Press the
Select/on/off
Knob for at least 2 seconds,
Then press the + button . Now You have 30 seconds time to pair with the BPA 100.
•
For the
Albrecht Rider
, please make sure that it is off before. Press the central (the aluminium-coloured) knob until both, the red and the blue LED’s start flashing.
Release the knob, You will have about 2 minutes time to start the procedure with the BPA 100 now.
•
Now start pairing with
BPA 100
. Keep the button pressed about 8-10 seconds. After the first 4 seconds it will flash 4 x green. Do not release the button now, keep it
further pressed until both LED’s start flashing rapidly. Release button.
•
After pairing is successful, the flashing will finish.
You can now
start the communication
link by pressing the
Talk (or Start/ Stop)
button. Some Headsets (like the VEMAR and BMW Bluetooth motor bike helmet) may use
key functions different from the standard Bluetooth headset protocol. In such cases it is possible to
start and to stop the communication link at the BPA 100
instead at the
headset. Just press the central knob at the BPA 100 for about ½ second to start or to stop the audio connection. The connection is established when the
green LED
is on
continuously
. Please note that motor bike PMR446 radio communication is different from cellular phone communication. While the cellular communication is started from
standby by incoming calls, it is necessary that for PMR communications the Bluetooth connections remains active during the whole time period. Otherwise it is not possible to
hear the short conversation periods over the PMR radio. Please note that only
one single helmet
can be communicate with PMR 446 via BPA 100 at the same time.
