Battery Install
1. Press down on the battery compartment cover on the bot-
tom of the scanner and slide the cover in the direction of the
arrow to remove it.
2. Slide the battery holder out of the battery compartment.
3. If you are installing individual batteries, insert six AA batte-
ries in the battery holder as indicated by the polarity symbols
(+ and -) marked on the battery holder.
4. Slide the battery holder or battery pack into the compart-
ment.
Caution: The battery holder or battery pack fits only one way
inside the battery compartment. Do not force it.
5. Replace the cover.
When battery power is low, BATT flashes and the scanner
beeps about every 3 seconds. Immediately replace all six non-
rechargeable batteries or recharge the rechargeable batteries
or battery pack.
Caution: Always dispose of old batteries promptly and proper-
ly. Do not bury or burn them.
Using Standard AC Power
To power the scanner from AC power, you need an AC adap-
ter.
Cautions:
· You must use an AC adapter that supplies 9 volts and deli-
vers at least 200 milliamps. Its center tip must be set to negati-
ve, and its barrel plug must correctly fit the scanner’s
PWR/CHG jack. The recommended adapter meets these spe-
cifications. Using an adapter that does not meet these specifi-
cations could damage the scanner or the adapter.
· When you finish using the AC adapter, disconnect it from the
AC outlet first. Then disconnect it from the scanner.
Plug the adapter’s barrel plug into the scanner’s PWR jack.
Then plug the adapter’s power module into a standard AC out-
let.
