Albion 860-48-59-6561 Operator'S Manual Download Page 2

Page 2

1.

CAUTION! 

  To  reduce  the  risk  of  injury,  charge  only

ALBION

 12 and 14.4 Volt Series 1000 battery packs in this charger.

Other  types  of  batteries  may  explode,  causing  personal  injury  or

damage.

2.

AVOID DANGEROUS ENVIRONMENTS.

  Do not use charger in rain,

snow, damp or wet locations.  Do not use battery pack or charger in

the  presence  of  explosive  atmospheres  (gaseous  fumes,  dust  or

flammable materials) because sparks may be generated when insert-

ing or removing battery pack, possibly causing fire.

3.

CHARGE  IN A  WELL  VENTILATED AREA.

    Do  not  block  charger

vents.    Keep  them  clear  to  allow  proper  ventilation.    Do  not  allow

smoking or open flames near a charging battery pack.  Vented gases

may explode.

4.

MAINTAIN CHARGER CORD.

  When unplugging charger, pull plug

rather than cord to reduce the risk of damage to the electrical plug and

cord.  Never carry charger by its cord.  Keep cord from heat, oil and

sharp edges.  Make sure cord will not be stepped on, tripped over or

subjected  to  damage  or  stress.    Do  not  use  charger  with  damaged

cord or plug.  Have a damaged cord replaced immediately with identi-

cal  replacement  parts  (see  “Maintenance”).

5.

DO NOT USE CHARGER OR BATTERY PACK IF

 it has received a

sharp  blow,  been  dropped  or  damaged  in  any  way.    Do  not  disas-

semble.  Incorrect reassembly may result in the risk of electric shock,

fire or exposure to battery fluids.  If it is damaged, contact 

ALBION

ENGINEERING Co.

 for a return authorization number.

6.

CHARGER IS RATED FOR 120 VOLT AC ONLY.  

Charger must be

plugged into an appropriate receptacle.

7.

USE ONLY RECOMMENDED ATTACHMENTS.  

Use of an attachment

not recommended or sold by 

ALBION ENGINEERING

 may result in a

risk of fire, electric shock or personal injury.

8.

DO NOT USE AN EXTENSION CORD UNLESS IT IS ABSOLUTELY

NECESSARY.  

Using the wrong, damaged or improperly wired exten-

This manual contains important safety and operating instructions for battery chargers.  Before using the battery charger, read this manual as well as any

labels on the charger, battery pack and tool.

sion  cord  could  result  in  the  risk  of  fire  and  electrical  shock.    If  an

extension cord must be used, plug the charger into a properly wired

16 gauge or larger extension cord with pins that are the same num-

ber, size and shape as the pins on the charger.  Make sure that the

extension cord is in good electrical condition.

9.

DO NOT BURN, MUTILATE OR DISASSEMBLE BATTERY PACK.

The battery pack can explode in a fire.  Mutilation may expose battery

fluids,  causing  burns.

10.

BATTERY FLUIDS CAUSE SERIOUS CHEMICAL BURNS.

  Never al-

low  contact  with  skin  or  eyes.    If  a  damaged  battery  pack  leaks

battery fluids, use rubber or neoprene gloves to dispose of it.  If skin

is  exposed  to  battery  fluids,  wash  with  soap  and  water  and  rinse

with vinegar.  Remove and dispose of contaminated clothing.  If eyes

are  affected,  immediately  flush  with  water  for  15  minutes  and  seek

medical attention.

11.

DO NOT SHORT CIRCUIT.

  A battery pack will short circuit if a metal

object  makes  a  connection  between  the  positive  and  negative  con-

tacts on the battery pack.  Do not place a battery pack near anything

that may cause a short circuit, such as coins or keys in your pocket.

A short circuited battery pack may cause fire and personal injury.

12.

UNPLUG CHARGER

 when not in use.

13.

TO REDUCE THE RISK OF ELECTRIC SHOCK

, always unplug charger

before  cleaning  or  maintenance,  turning  off  controls  will  not  reduce

this risk. Use a Ground Fault Circuit Interrupter (GFCI) to reduce shock

hazards.

14.

STORE YOUR BATTERY PACK AND CHARGER

 in a cool, dry place.

Do  not  store  battery  pack  where  temperatures  may  exceed  120°F

(50°C) such as in a vehicle or metal building during the summer.  Charger

will charge

 

the battery at the most rapid rate when the temperature is

between 41°F (5°C) and 113°F (45°C).  When the battery temperature

is outside that range, charging will take longer.

GENERAL SAFETY RULES

READ AND UNDERSTAND ALL INSTRUCTIONS.

Failure  to  follow  all  instructions  listed  below,  may  result  in  electric  shock,

fire  and/or  serious  personal  injury.

WARNING!

SAVE THESE INSTRUCTIONS

1. Red control light

Light  off  indicates:

Charger is ready for operation
Battery  pack  is  charged

Maintenance charging

Continuous light indicates: Charging (Fast, if battery temperature

is between 41°F (5°C) and 113°F (45°C)

Flashing light indicates:

Battery pack is too hot or too cold (Charging

will begin automatically when battery reaches

correct  charging  temperature)

2. Instruction label
3. Electrical  contacts
4. Battery  pack  port
5. Vents
6. Nameplate (on back of charger)
7. Key hole slots:

Mounts  charger  vertically

(on  bottom  of  charger)

8. Cord  wrap:

Stores  excess  cord

(on  bottom  of  charger)

3

4

2

6

8

7

5

1

FUNCTIONAL DESCRIPTION

Summary of Contents for 860-48-59-6561













Reviews: