Alberici Timebox S, Operator'S Manual

Page: 5 / 12

ACTIVE ONE ALBERICI Istruzioni Originali
Rev. 1.00 Pagina 5
3. Size
4.
Electrical connections
Electrical cables must not be powered during installation!
The TIMEBOX S is available for 4 different power supply values: 230Vac, 24Vac, 24Vdc, 12Vdc. When
placing your orders, please specify which presetting you need: the interface Servo-board shall be prepared
accordingly.
The interface Servo-board is used to produce 12Vdc power to the coin acceptor, and to provide as well the relay dry
contact when the coin acceptor sends out the credit signal.
A 10p flat cable connects the acceptor to the Servo-board.
This one is also connected to the Timebox chassis by a Ground terminal.
Power the Servo-board on the 3p socket J1, according to the following pattern:
230 Vac 24Vac 24Vdc 12Vdc
Pin 3: line 230Vac line24Vac +24Vdc +12Vdc
Pin 2: neutral neutral 0Vdc 0Vdc
Pin 1: GND GND
It is possible to disable coin acceptance in any of the following two ways:
a)
Electronically - Pins 7/8 of green connector J2: provide any Vdc (+) or Vac (line value) to pin 7, and
respectively 0Vdc (-) or Neutral Vac to pin 8.
b) Mechanically - move to OFF the dip-switches located on the coin acceptor. Move them back to ON when
you want to resume coin acceptance.