A
A
A
A
2.
Cleaning the Note Validator
9.1
Manual cleaning
The ability of acceptance may decrease due to the accumulation of dust and cellulose dust released
by banknotes during transit, or because of residues or sprays, which may spread on the detecting
sensors and on transmission parts.
It is therefore recommended to
clean these parts at least monthly
, as indicated below.
1.
Turn power off and unplug the cable
from the 10-pin connector interface.
Press the yellow button C, located
under the reader, to release the main body
from the faceplate, and slide it backwards.
2.
Move the D button upward, hold it while sliding the cover backwards; then lift the latter up
and rotate it 180° to the right side.
3.
Gently wipe the sensors with a clean, lint-free tissue, or with a cotton swab, or with a small
sponge, possibly moistened with isopropyl alcohol.
4.
Completely remove the dust and residues from the 4 silicone rollers, and from the 4 elastic
matching wheels which are located in the lower surface of the upper lid. To remove the most
stubborn dirt from rollers and wheels, use
isopropyl alcohol.
PAY ATTENTION:
do not use
organic detergents (ex. alcohol,
thinners or petrol). Use only
isopropyl alcohol.
1.
Sensors
A
2. Rollers
3. Elastic matching wheels
C
B
D
C
WARNING! Do switch power off
before opening the machine!
