Alber viamobil eco, User Manual

Page: 13 / 37

0
2.4 Selecting Requested Speed
The following features are assigned to the data on the scale [14] on the headset
[11]:
Setting „0“: viamobil is switched off; LED status display is not active.
Settings 1-6: positions of the speeds to be attained (from 1 = 1 km/h to
6= 6 km/h, continuously selectable), LED status display lights up.
Setting „Roll“: pushing operation for fixing viamobil to the wheelchair, as descri-
bed in the previous chapter, 2.3; LED status display lights up.
Turn the operating button [12] to the appropriate position (1-6) to select a user-
defined speed; turn to „0“ to switch off the device.
2.5 Driving Forwards
Hold the viamobil by the handles [7] with both hands.
Press the whole handle bar carefully as far down as possible until it stops
The viamobil travels forwards as long as the handle bar is pressed downwards.
If the handle bar returns to its original position (middle position), the viamobil stops
and the brakes are tightened.
2.6 Driving Backwards
Hold the viamobil by the handles [7] with both hands.
Pull the whole handle bar carefully upwards until it cannot go any further.
The viamobil travels backwards as long as the handle bar is pulled upwards.
If the handle bar returns to its original position (middle position), the viamobil stops
and the brakes are tightened.
Your viamobil is protected against unintentional driving features. It is therefore
not possible to operate the handle bar [8] first and then switch on the viamobil.
If you still attempt to do this, the device blocks and an error code is displayed
(6x blinking light) on the LED status display [3] (see chapter 7.2).
In the event of this please leave go of the handle bar on the viamobil; the
device will then switch itself on automatically.
•
•
•
•
•
•
•
12 14 13 12 14 13
7
7
7
7
7
7
7
7
GA-V14-USA.indd 10 18.09.2006 11:51:26