31
•
Signal from: This parameter can only be obtained from the battery, therefore, will be
the only option in the drop-down.
•
Physic Variable: the only option is current.
•
Units: mA or A
•
Limits high and low: these limits will be used to set an alarm.
•
Filter Level: Indicate if the measures filter has been made with a low, medium or high
level.
•
Sensor Type: You have some predefined sensors. You can choose a sensor type and
make some changes.
If you press on “Measured” you will see the current value:
You can click on “Measured” and see the current value or you can write the theoretical value of
the sensor output corresponding to the measurement.
The “Calibrated” button is used to test if your calibration table is correct. Note that you must
click on “Save” before making the test.
