Mainboard KM61S-AM2
13
Reset button Header
(Red)
: RST
This header can be attached to a momentary SPST switch (reset button) cable on your case
front panel. The switch is normally left open. When the switch closed, it will cause the
mainboard to reset and run the POST (Power-On Self Test).
Sleep button Header
(Black): SLP
If your case front panel has a sleep control cable, attach it to this header. The system will get
into sleep mode when you press the button by setting the system sleep mode.
Power LED Header
(
(
Y
Y
e
e
l
l
l
l
o
o
w
w
)
)
:
PWR_LED
The mainboard provides a power LED header. If there is a 3-pin power LED cord on your
case front panel, you can attach it to the 3-pin power LED header. Then the power LED will
illuminate while the system is powered on.
Power-on button Header
(
(
B
B
l
l
a
a
c
c
k
k
)
): On/Off
This header can be attached to a power switch cable on your case front panel. You can turn
your system on or off by pressing the button attached to this power switch cable.
Headers & Jumpers
Front USB Header: JUSB2/JUSB3
This mainboard provides four onboard USB 1.1/2.0 ports (back panel) that attach to USB
devices. There are two additional USB headers that can be connected by cables to four more
USB ports on the front panel of your case giving you a possible 8 USB ports.
Pin
Assignment
Pin
Assignment
1 +5V
(fused)
2 +5V
(fused)
3 USB-
4 USB-
5 USB+
6 USB+
7 Ground
8 Ground
JUSB2/3
9 Key
10
N/A
Attention
If you are using a USB 2.0 device with Windows 2000/XP, you will
need to install the USB 2.0 driver from the Microsoft
®
website. If you
are using Service pack 1 (or later) for Windows
®
XP, and using
Service pack4 (or later) for Windows® 2000, you will not have to install
the driver.
