Mainboard KM61S-AM2
11
Rear Surround-out
（
black
）
This port is only functional for the output of the surround sound rear speakers when the 8/6/4/2
channel audio driver is installed and enabled.
Connectors
Floppy Disk Drive Connector: FDD1
The mainboard provides a standard floppy disk drive connector (FDD) that supports 360KB/
720KB/ 1.2MB/ 1.44MB/ 2.88 MB floppy disk drives using a FDD ribbon cable.
Primary IDE Connector: IDE1
The mainboard provides one IDE connector that supports Ultra ATA 66/100 IDE devices. You
can attach a maximum of two IDE devices, such as hard disk drive (HDD), CD-ROM,
DVD-ROM, etc. using an IDE ribbon cable.
In general, two IDE devices can be attached onto one IDE connector. If you attach two IDE
HDDs, you must configure one drive as the master and the other one as the slave. In this case,
one optical device i.e., CD-ROM, DVD-ROM…etc. should be attached to this connector as well.
Serial ATA II Connector:
JSATA1/ JSATA2
The two SATA II connectors support 3 Gbps transmit rate, and one SATA II connector only can
attach one SATA II HDD of each time using SATA cables.
Pin
Assignment
Pin
Assignment
1 Ground
2 TX+
3 TX-
4 Ground
5 RX+
6 RX-
1
JSATA1/2
7 Ground
This mainboard supports RAID 0/ 1 mode; refer
Appendix II
for more
information.
This mainboard supports multi-channel audio system which allows you to
transform your 2 speaker audio system into 8/ 6/ 4 speaker audio system.
See
Appendix I
for more information.
