KM18G PRO/ KM18G PRO II
38
Video Off Method
This option determines the manner in which the monitor goes blank.
Options:
V/H SYNC+Blank
This selection will cause the system to turn off the vertical and horizontal
synchronization ports and write blanks to the video buffer.
Blank Screen(default) This option only writes blanks to the video buffer.
DPMS Support
Initial display power management signaling.
HDD Power Down
When enabled, the hard disk drive will power down after a certain configurable period of system
inactivity. All other devices remain active.
Options: Disabled (default)
、
1 Min
、
2 Min
、
3 Min
、
4 Min
、
5 Min
、
6 Min
、
7 Min
、
8 Min
、
9 Min
、
10 Min
、
11 Min
、
12 Min
、
13 Min
、
14 Min
、
15Min
HDD Down In Suspend
This allows you to enable/ disable the hard driver power down in the suspend state.
Options: Disabled (default)
、
Enabled
Soft-Off by PWRBTN
In situations where the system enters a “hung” state, you can configure the BIOS so that you are
required to pre the power button for more than 4 seconds before the system enters the Soft-Off state.
Options: Delay 4 Sec, Instant-Off (default).
LAN Wake Up
To use this function, you need a LAN add-on card which supports power on functions. As well as the
wake-up on LAN jumper. Options: Disabled (default)
、
Enabled
PCI PME Wake Up
This option will also cause the system to wake up with any onboard LAN activity.
Options: Disabled (default)
、
Enabled
Ring Wake Up
This option allows you to awaken the system upon receiving an incoming call to modem device.
Options: Disabled (default)
、
Enabled.
