Mainboard K8SLI-AM2
16
CDIN
1. Turn off your system and disconnect the AC power cable.
2. Set JBAT header to OFF (2-3 Closed).
3. Wait several seconds.
4. Set JBAT header to ON (1-2 closed).
5. Connect the AC power cable and turn on your system.
6. Reset your new password.
Audio Configuration
CD-ROM Audio-In Connector: CDIN
The CD-IN connector is used to attach an audio cable to audio devices
such as CD-ROMs, DVD-ROMs etc.
Front Audio Connector: AUDIO
If your case front panel has audio ports, you can connect them to the Front Audio Header of this
mainboard. First, you must remove the jumper caps on this header and then attach the cables
from the front panel to the pins on this header. You can use both the front audio panel and back
panel audio simultaneously. If you are not using front panel audio ports, leave the jumper caps
on the header pins (Note: pins 5-6 and 9-10) to avoid problems with the back panel audio ports.
AUDIO
Pin
Assignment
Pin
Assignment
1 AUD_MIC
2 AUD_GND
3 AUD_MIC_BIAS
4 AUD_VCC
5 AUD_FPOUT_R
6 AUD_RET_R
7 HP_ON
8 N/A
9 AUD_FPOUT_l
10 AUD_RET_L
Slots
PCI-Express x16 Slot: PE3
This mainboard is able to install a graphics card, which the PCI-Express x16 interface,
supporting one-way bandwidth up to 4 GB/s, is compatible to this PE3 slot.
