Albalá Ingenieros PDC3002C01, Manual, Page: 20 / 28

Albalá Ingenieros | Manual PDC3002C01
The following functions of the PDC3002C01 can be performed remotely:
- Configuration of the conversion operation.
- Supervision of the status of the input signals.
4.2.1. Details of the PDC3002C01 registers
The PDC3002C01 module provides control and status registers that can be read and
written by means of specific commands described in the communication control
module user manuals.
The parameter information grouped in the CONTROL or RAM sections is stored in
volatile memory. Any modifications to the parameters will be lost when the module
power supply is disconnected unless the "EEPROM Save" button within the software
has been pressed.
The STATUS section parameters are read-only and cannot be modified.
The EEPROM section parameters are rarely used and are stored directly in non-volatile
memory.
The parameters that can be controlled and supervised remotely for each version of
the firmware are listed below:
VERSION 1.X
CONTROL
Name add ext msk snmp trap Description
BLACK_A 0x00 0x01 Y N Allows selecting the signal at the output (Section A)
0=CCVS input, 1=Black burst
COLOUR_A 0x00 0x02 N N Allows selecting if the output is colour or black and white (Section A)
0=Enabled, 1=Disabled
INS_EDH_A 0x00 0x04 N N Allows selecting if EDH packets are inserted in SDI signal (Section A)
0=Enabled, 1=Disabled
DIS_VCXO_A 0x00 0x08 N N Allows adding a VCXO for jitter reduction (Section A)
0=Enabled, 1=Disabled
OUT_ON_FAIL_A 0x00 0x10 Y N Allows selecting the output signal if input signal fails (Section A)
0=Black, 1=No signal
LINES_A 0x00 0x20 Y N TV input signal line number (Section A)
0=625, 1=525
BLACK_B 0x01 0x01 Y N Allows selecting the signal at the output (Section B)
0=CCVS input, 1=Black burst
COLOUR_B 0x01 0x02 N N Allows selecting if the output is colour or black and white (Section B)
0=Enabled, 1=Disabled
INS_EDH_B 0x01 0x04 N N Allows selecting if EDH packets are inserted in SDI signal (Section B)
0=Enabled, 1=Disabled
DIS_VCXO_B 0x01 0x08 N N Allows adding a VCXO for jitter reduction (Section B)
0=Enabled, 1=Disabled
OUT_ON_FAIL_B 0x01 0x10 Y N Allows selecting the output signal if input signal fails (Section B)
0=Black, 1=No signal
LINES_B 0x01 0x20 Y N TV input signal line number (Section B)
0=625, 1=525
DCM_FAIL_A_MASK 0x02 0x01 N N Allows masking FPGA DCM fail (Section A)
0=Disabled, 1=Enabled
DCM_FAIL_B_MASK 0x02 0x02 N N Allows masking FPGA DCM fail (Section B)
0=Disabled, 1=Enabled
UNLOCK_A_MASK 0x02 0x04 N N Allows masking VCXO unlock fail (Section A)
0=Disabled, 1=Enabled
20