Albalá Ingenieros DEM3000C01, Manual

Page: 13 / 30

Albalá Ingenieros | Manual DEM3000C01
- Switch 8 configures the module to insert two audio groups into an SDI video signal.
These switches comes preset to ON from the factory.
SECTION A S1 ON S1 OFF
Switch 1. Embed enable yes no
Switch 2. Erase before embed no yes
Switch 3. Number of channels per group 4 2
SECTION B
Switch 4. Embed enable yes no
Switch 5. Erase before embed no yes
Switch 6. Number of channels per group 4 2
COMMON
Switch 7. Audio sample bit length 20 24
Switch 8. Operating mode
2 sections
1 group
1 section
2 groups
3.6. Installing the module in the mounting frame
The steps needed to install the DEM3000C01 module with the rear board in the
mounting frame are:
1 - Disconnect all power cords from the power supplies of the mounting frame.
2 - Remove the blank panels covering the front and rear of the empty bays chosen for
installing the DEM3000C01 in the mounting frame.
3 - Install the DEM3000P02 rear board ensuring that its 12-pin connectors are properly
aligned with the mounting frame´s mating connectors. Check that the orientation of
the board is correct by looking at the placement of the text printed on it according to
the illustration below.
4 - Attach the rear board to the mounting frame with two M3 metric screws and tighten.
5 - Verify that the main board is configured according to the user requirements. The
configuration process is detailed later in the INSTALLATION section of this manual.
6 - Insert the DEM3000P01 board (main board of the DEM3000C01 module) into the
front of the mounting frame. The edges of the card slide into two plastic guides inside
the mounting frame.
7 - Affix the main board to the mounting frame using the two screws included on the
front panel.
After these steps, the module is ready to be connected to other equipment.
13