DTW - Digital Torque Wrench
5
MEMORY
The DTW can store up to 50 readings in memory for recall on the display.
To store a reading in memory set the wrench to P (peak) mode and take a
reading. When the reading is on the display press the OK key to store the
reading and zero the wrench.
To recall stored readings press the M key four times, the display will alter-
nate between n0XX (XX = the reading number) and the stored reading.
Press the up / down arrows to toggle between readings. Press the menu
key twice to return to measurement mode.
To clear the stored readings press the M key five times. CLr will be shown
on the display. Press the C key twice to confirm the deletion of the read-
ings. WARNING, this procedure will delete the entire contents of the
memory, it is not possible to delete individual readings.
MAINTENANCE AND STORAGE
1. Do not Over-torque (105% of Max. torque capacity). Over-torquing can
damage wrench or cause it to lose accuracy.
2.
Do not shake or shock this wrench violently or drop it to ground.
3.
Do not use this wrench as a hammer.
4.
Do not expose to excessive heat, humidity, or direct sunlight.
5.
Do not use the wrench near water.
6. If the wrench gets wet, wipe it with a dry lowel as soon as possible.
The salt in seawater can be especially damaging.
7. Do not use organic solvents, such as alcohol or paint thinner when
cleaning the wrench.
8.
Keep this wrench away from magnets.
9. Do not expose this wrench to dust or sand as this could cause serious
damage.
10. Do not apply excessive force to the LCD panel.
