Alamo John Deere 6215, Assembly & Instruction Manual, Page: 87 / 128

© 2004
Alamo Group Inc.
Section 7 - 5
Machete (JD-62, 63, 6420 Asy Man) 10/04
Frame Rail Installation 2 WD & 4 WD
Re-Install High Frame to Tractor:
1.
High Frame Paint. Re-Paint or Touch up Paint
on High Frame now before lowering it on to Tractor.
Keep in mind there will be one more Place to Weld
on High frame that will need touch up Paint later,
The Counter Weight Lug that weld to High frame
when installed later.
2.
High Frame Mounting to Tractor. This is a two
Person Job to maintain control of High Frame and
guide it down over frame rails.
(See Figure 14)
3.
Align High Frame. The High frame with the
Mounting tubes welded to it will sit down over
Frame Rails. The welded on Mounting tubes will
slide down into the Angle mounts that are welded to
the Frame rails.
(See Figure 15 & 16). Both sides
must go down evenly.
4.
Aligning Mounting Holes. The Holes in the Angle
Mounts welded to the Frame Rail and the Mounting
Tube Plates that are welded to the High Frame
must be aligned. This can be done with a Pry Bar
inserted into one of the holes and moved around
(See Figure 17). In some cases the Frame Rails
may have to be moved slightly, this is the reason
the Bolts were only snugged and not tightened. Do
not take Hoist off of High Frame untill all Bolts are
tightened. There are 8 bolts and Nuts that must be
installed into the holes of the Angle Mounts. Snug
these
Figure 14
Figure 15
Figure 16
Figure 17
Aligning on the LH side
between the front and rear
angle mount.
Aligning on the RH side
between the front and rear
angle mount.