Alamo John Deere 6215, Assembly & Instruction Manual, Page: 123 / 128

© 2004 Alamo Group Inc.
10 -11
Machete (JD- 62, 63,6400 Asy. Man.) 10/04
Note:
Item 3 is welded to both LH and RH Frame Rails from the factory. Item 4 will be welded on during
assembly procedures. Do not weld on any components until instructed to do so, then check instructions
carefully because some components are only to be tack welded then removed to be welded later.
Actual Tube Design may vary from drawing above. Shown above is a general Frame Rail
Weldment. While Frame Rails may be designed different the mounting process will be the same.
3 Point Arm Stabilizers on tractor will have to be removed when mounting Frame rails remounted
under frame rail rear plates. If stabilizer need to be modified to remount them it will be customers
responsibility.
Item Part No. Qty Description
1. 02978468 1 Frame Rail Weldment, LH (Shown)
02978469 1 Frame Rail Weldment, RH (Not Shown)
3. ------------ 2 Rear Mounting Plate (Welded on LH and RH Frame Rail)
4. 02725900 2 Support Plate (not welded to frame rail when received)
5. 02974704 2 Axle Strap, Fit above Axle. (LH & RH side )
6. 02966321 2 Bolt, Axle Strap Hex Head 1" - 11 NC X 12" PL
02966556 2 Bolt, Axle Strap Hex Head 1" - 11 NC X 11" Pl (RH Side)
7. 02030300 4 Locknut, 1" - 11NC
8. 02975738 6 Bolt, Hex Head M20-P1.5 X 70 mm GR 10.9 (LH Side)
002528 6 Bolt, Hex Head M20-P1.5 X 110 mm GR 10.9 (RH Side)
9. 02971158 8 Lockwasher, 20 mm
10. 00679800 2 Hose Support Bracket Pigtail (Weld on Hose Support.
Mount Kit Component Identification
1
3
4
5
Frame Rails & Axle Straps
6
7
8, 9
10