Alamo Interstater TS-100A, TS-115A,, Assembly Instruction Manual

Page: 23 / 72

© 2004
Alamo Group Inc.
Section 3 - 7
Interstater (NH TS-100A , 115A , 125A & 135A Asy. Manual) 06/04
Figure 14
LH Wing Side Of
Tractor
Remove this
Straight Bulk
Head Fitting &
Replace it with
an Elbow
Install Driveshaft, Pump & Tank:
(continued)
20.
Change Straight Bulkhead fitting to an
Elbow Fitting. There is a straight bulkhead fit-
ting installed into main frame crossmember that
should be changed to a 90 " elbow< (See Figure
14,15,16 & 17).
21.
Connect Motor Pressure Supply Hoses to
Main Frame Cross Member. The Tandem Pump
has two pressure hoses. The Rear (closest to
Tractor Engine) it the supply for the RH Wing Motor.
The Outer Pump is the LH Wing Motor Pressure
Supply. The hose for the RH Wing should be marked
with a red plastic tie on it, the other hose is not
Identified. Connect these two hoses at the Main
frame crossmember now (See Figure 16 & 17)
22.
Connect Hoses to correct Bulkhead fittings
is important here . The Pressure hoses MUST be
connected correctly to the correct bulkhead fitting. If
they are not they will damage the head cooling tubes
and/or other components. DO NOT connect any
hoses until instructed to do so. Always double check
the hose routing to make sure they are correct.
Pump - Driveshaft - Hyd tank
Figure 15
LH Wing Side Of
Tractor
Install this Elbow
Bulk Head Fitting in
place of straight one.
Figure 16
LH Wing Side Of
Tractor
Install Pressure Hose from Tandem Pump
to Bulk head fitting here for LH Wing
Motor
Install Pressure Hose
from Tandem Pump to
Bulk head fitting here for
RH Wing Motor
Pressure Hose f/ Tandem
Pump to Bulk head fitting here
, LH Wing Motor
Pressure Hose f/ Tan-
dem Pump to Bulk
head fitting here , RH
Wing Motor
Figure 17