Assembly
456251_a
19
Open the machine
5 loosen the handscrewn (2a).
6 fold back the feeder tube (2b).
7 Place the lower half on the side ans dispose
of the packaging.
8 Position the washers 8,4 x 21 x 4 and legs on
the housing and insert screws M8 x 40 (3).
9 Attach the legs using the nuts M8 and was-
hers 8,4 x 16 (DIN 125) supplied. (Assembly
the same on left and right side) (4)
ADVICE
For easier assembly of the wheel axle,
do not fully tighten the nuts simply hold
the legs in position the screws.
Assemble wheel axle and wheels
You will need:
1 axle
2 screws M8 x 40
2 washer 8,4 - DIN 125
2 nuts M8
2 wheels with ball bearings
2 extension screws (= wheel axles)
2 nuts M10
2 corrugated washer 13 x 24 x 0,5
2 retainig washer 10,5
1 Using the 2 screws, 2 washers 8,4 and nuts,
screw the axle onto the legs. (5)
2 Ten tighteen the 6 nuts on the legs.
3 Position the lower part of the shredder on the
legs.
4 Place the upper part of the shredder on the
top of the lower part. (6)
5 Allow the upper part to engage int the central
retainer.
6 Push the rod through the holes in the upper
and lower parts of the shredder.
7 Screw the nut back onto the rod. (7)
8 Tighten the handscrew. (2a)
9 The wheels (with ball bearings fitted) are se-
cured to the axle using the extention screw,
corrugated washer 13 x 24 x 0,5, retainig wa-
sher 10,5 and nut. (8)
10 Fit the wheel covers onto the wheels.
Assembly tools
Included with the shredder is the following:
1 box spanner SW 10
1 open-endde spanner SW 10/8
1 Torx-bitT30
Assembly of feeder funnel
Tools:
1 Screwdriver
4 Bolts M6 x 25
4 Washer A6,4 DIN 9021
1 Fit the projective rubber guard on top of the
tube. (9b)
2 Position the funnel on top of the tube. (9c)
3 Secure the funnel to the tube using the 4
screws and washers. (9d)
Assembly tube
Montage Fülltrichter
Assembly tools:
4 washer 6,4 - DIN 125
4 retaining washer 6,4
1 screw M6 x 25
3 screw M6 x 16
1 Position the tube on top of the shredder. (9a)
2 Secure the tube on top of the shredder.
CLEANING AND MAINTENANCE
CAUTION!
Do not spray with water
Removing feeder funnel
1 Switch off shredder
2 Wait until cutter has com to a complete stop.
3 Disconnect mains plug.
4 Loosen screw and pull out (2a)
CAUTION!
For replacement of this screw only origi-
nal part!
Safety disconnection switch
The safety disconnection switch i acted by pulling
the screw out.
The motor can not be started with the normal ro-
cker switch.
Aftre replacing the feeder funnel with
the original
screw
, the motor can be re-started with the rocker
switch.
ADVICE
Very important for your own safety!
5 Turn the safety lever (central catch) and lift
the tube back.
