AL-KO Solo 6646, Instructions For Use Manual

Page: 54 / 536

GB
54 6646 | 6651 | 6656
Help in case of malfunction
Maintenance schedule
One-
time af-
ter 5 op-
erating
hours Before
starting
work Every
week Every
50 op-
erating
hours Every
100 op-
erating
hours As re-
quired Before/after
the season,
annually
Clean the chain groove/
oil hole X
Clean the inside of the
protective cover X
All accessible screws
(except set screws)
Retighten X X X
Complete machine
Visual inspection for con-
dition X
Clean (including air inlet,
cylinder cooling vanes) X X X
9 HELP IN CASE OF MALFUNCTION
CAUTION! Risk of injury. Sharp-edged
and moving appliance parts can lead to injury.
■
Always wear protective gloves during mainte-
nance, care and cleaning work.
NOTE If you encounter any malfunctions
that are not listed in this table or that you cannot
rectify yourself, please contact our customer ser-
vice.
Malfunction Cause Remedy
The engine cannot be started
or dies immediately. Incorrect operation Start the engine as described in
these operating instructions.
Dirty spark plug or faulty
electrode gap Clean or replace the spark plug.
Dirty air filter Clean or replace the air filter
The guide rail and saw chain
become hot when running.
Generation of smoke. The saw chain is tensioned
too tightly. Reduce chain tension.
Oil tank is empty. Replenish the saw chain oil.
The oil entry hole and/or
groove of the guide rail are
dirty. Clean the oil entry hole and groove
of the guide rail.
Engine running, but the saw
chain does not move. The saw chain is tensioned
too tightly. Reduce chain tension.
Device errors Contact an AL-KO service centre.