AL-KO G&S Chassis Caravan, Warranty And Service Hand Book, Page: 26 / 36

Maintenance
Component
Type of use
Work required
Normal road use “Off-road” use
Wheel
bearings Every 12 months or
10,000 km Every 6 months
or 5,000 km
Check: With wheel lifted clear of the ground
check for excessive play by attempting
to move the top of the tyre inwards and
outwards. Rotate wheel and listen for
abnormal sounds. Adjust as required.
Service: remove, clean and check. Check
condition of brake linings, brake drums,
bearings and seals and replace as required.
Repack bearings with high quality wheel
bearing grease. Tighten axle nut while
rotating hub in the direction of tightening
until all clearance is taken up. Back off to
next slot and install new split pin. Re-fit
grease cap.
WARNING: Incorrectly adjusted or poorly lubricated wheel bearings may result in failure of bearings,
seals, axles, brakes and/or hubs
*Shock
absorbers
(where fitted)
Every 12 months or
10,000 km Every 6 months
or 5,000 km
Inspect for damaged or worn mounting
bushes, impact damage, broken, cracked or
bent body, leakage or lack of damping (rock
caravan to check). Replace as required.
Shock absorbers of each axle must be
replaced in pairs.
*Bump stops
(Independent
Suspension
only)
Every 12 months or
10,000 km Every 6 months
or 5,000 km
Inspect for cracking or breakage –
replace as required. Such damage may
be indicative of over inflated tyres,
overloading, over speeding or use over
unsuitable terrain – rectify usage as
required.
*Over-travel
chains
(Independent
Suspension
only)
Every 12 months or
10,000 km Every 6 months
or 5,000 km
Inspect for cracking or breakage – replace
as required. Such damage may be
indicative of worn shock absorbers, over
inflated tyres, overloading, over speeding or
use over unsuitable terrain – rectify usage
as required.
Warranty and Service Hand book
27
GandS GS Warranty Book AAC 2019.indd 26 22/10/2019 12:55:39 PM