AL-KO 130 930, Instructions For Use Manual

Page: 29 / 253

441152_d 29
GB
1. Fill with petrol via a funnel.
2. Clean and tightly close
the tank filling opening.
Filling with engine oil ( 4)
Unscrew the oil filling lid
and store it in a
clean place.
3. Fill with engine oil via a funnel.
4. Clean and tightly close
the oil filling opening.
Start-up
Important!
Generator must be safely earthed
The camera symbol on the following
pages refers to the figures
on pages 4
–7.
Earthing the machine
Important - Electric shock!
Do not use a bare wire for earthing.
Important!
Generator must be safely earthed
Use an earthing wire with a cross-
section of at least 2.5 mm
2
for
earthing
Connecting the earthing wire
( 1)
Press the end of the earthing wire under the
nut of the earthing terminal.( 1/1)
1. Secure the earthing wire by tightening the
nut
2. Connect the other end of the earthing wire
to an earthing spike (e.g. metal rod)
3. Put the earthing spike securely into the soil
Connecting the starter battery
(AL-KO 6500-C only)
( 6)
1. Connect the red battery cable with the
positive terminal of the starter battery.
Tighten using screw and nut
2. Connect the green battery cable with the
negative terminal of the starter battery.
Tighten using screw and nut
3. Slide rubber grommets over the starter
battery terminals after tightening
Avoid contact between the positive
and negative terminal of the battery,
as this could damage the battery
Opening the petrol cock
( 6)
1. Open the petrol cock and
have petrol flow into
the carburettor
Choke
( 7)
1. Close the choke lever during a cold start.
2. When the machine is running at operating
temperature, put the choke lever in the
half-open position.
If the machine still does not start after
two attempts, open the choke lever
fully.
Starting the engine
Important
– Danger of poisoning!
Never run the engine in enclosed
spaces.
Important
– Danger of injury!
Important
– Danger of kickback!
Cable starter can return faster to the
engine than the cable can be released.
Cable starter
1. Set the ignition circuit breaker to "ON" (
8 )
2. Pull out the cable starter briskly, and then
allow it to wind back in slowly ( 9 )