U.S. Patent No. 8,856,780
Remote staRteR eRRoR coDes
- 1 OF 1
Remote staRteR eRRoR coDes:
notes
[X] numbeR oF PaRKing Light FLashes
Dia
gnostic
I WARNING: The following applies only when the parking
lights are connected and supported by the system.
01
Engine running.
02
Key in ignition at ON position.
II After a remote starter failure, the parking lights will fl ash
three [3x] times, then will fl ash [X] number times to
indicate an error code. See table.
03
N/A
04
Trunk is open.
05
Foot brake is ON.
06
Hood is open.
07
N/A
08
Tach failure.
09
N/A
10
System is in Valet Mode.
11
CAN communication failure
12
RS not synchronized. Start vehicle with OEM key for 15 sec before trying a new RS sequence.
Remote staRteR shutDown eRRoR coDes:
notes
[Y] numbeR oF PaRKing Light FLashes
Dia
gnostic
I WARNING: The following applies only when the parking
lights are connected and supported by the system.
01
Engine tach signal is lost.
02
N/A
II
If the engine shuts down after a remote starter sequence:
Press and hold the Trunk button and the Start button at the
same time for 2.5 seconds when using a 1-WAY remote.
OR
Press once [1x] on button “4” when using a 2-WAY remote.
The parking lights will fl ash four [4x] times, then will fl ash
[Y] number times to indicate an error code. See table.
03
Foot brake is ON.
04
Hood is open.
05
Engine RPM limiter is ON.
06
Glow plug timeout error.
07
Vehicle is moving (VSS).
08
Check engine warning light is ON.
09
Low fuel warning light is ON.
10
N/A
11
CAN communication failure during RS sequence.
www.autokinetix.com
Automotive Data Solutions Inc. © 2015
AKX-CH(RS)-CH8-[AKX-CH7]-EN
Page 16 oF 20
• 20150123
DOC.: #20226
