22
Unrecordable Material
In the unlikely event that there is some problem like loss of recorded video or audio content due to an
HDD malfunction, please be aware beforehand that we will bear no responsibility to compensate for
the content which could not be recorded or edited, for the loss of recorded or edited video, or for other
related direct or indirect damages.
If a power failure occurs
•
The content being recorded or timer recorded may be damaged if power failure occurs.
•
The content being played back may be damaged.
For important recording
•
If the HDD malfunctions, the content recorded on the HDD may be lost. If you wish to save
content permanently, we recommend copying or moving the content to Video or DVD.
NOTE
•
If a message indicating an HDD error is displayed (such as “ERROR IN HDD. CANNOT
OPERATE.”) and the HDD has malfunctioned, you cannot replace the HDD by yourself. If you
disassemble the Recorder, the warranty will become void. Also, recovery of data is
impossible. If playback is possible, re-record the recorded content onto a Video or DVD, and
contact the approved service centre with the details provided at the front and back of this
operation manual.
Hard Disk Operation (Recording / Playback / Time Shift Recording)
If the Recorder is used in a cold location (a location at low temperature), the drive will only allow live
viewing after power is turned on until the HDD is ready. During this time, the Recorder will not allow
Time Shift Viewing, recording, display of recording lists or playback of recorded programmes. Please
wait until the HDD is ready.
5.2. CONFIGURATION
You can configure the settings of your set
top box. Select Configuration from Setup
menu and press
OK
to enter this menu.
Press the BACK button on the remote to
exit
5.2.1. TV TYPE
Digital terrestrial television channels can
broadcast programmes in a widescreen
format which must be output differently to
normal and widescreen TV sets. This
function tells the receiver the screen format
of the TV connected so that broadcasts are
displayed correctly.Highlight the TV Type
line in the Configuration menu and use the“
3
/
4
” keys to select 4:3 if you have a standard TV set
connected or 16:9 if it is a widescreen TV. This function duplicates the selection made at the time of
first installation and can be used if you change TV sets.
5.2.2. TV OUT
The receiver can output RGB , CVBS and S-Video signal from the TV SCART on the rear panel.
Although the RGB format results in a better quality picture, not all equipment can cope with an RGB
signal.
