Manual Tuning.
If you need to add another station or signal from a Tv game or other source, rather than “Autosearch” you may
manually add another station. Ensure the additional apparatus is connected and turned on.
1.
Press the LCD-Menu button 3 times to select the TV Menu.
2.
Select CHANNEL and using the
f
or
e
buttons to select a free
location.
3. Press
the
d
button until the MANUAL SEARCH text is highlighted.
4. Press
the
f
button. To see the menu opposite.
5. Use
the
c
/
d
button to select UP or DOWN
6. Press
the
f
button to start searching
7.
The Tv will search from the point selected. If the signal is not seen
press the
c
/
d
buttons to select the opposite direction and the
f
button
again.
8.
When the required signal is seen, exit the menu by pressing “EXIT” or “MENU”
Note : If using a Tv game or similar, it is wise to have no other connection to the aerial connector as this may
confuse the situation.
Swap.
When AUTO SEARCH was done, the Tv stations would not be in the correct order, thus BBC1 would not be in
location 1. To place the stations into the correct order :-
1.
Press the LCD-MENU button 3 times to select the TV Menu
2. Press
the
d
button until SWAP text is highlighted.
3. Press
the
d
button to select FROM
4.
Using either the
f
or
e
buttons or Numeric buttons locate BBC1
Note :- it is useful to have a current Tv guide to hand.
5. Press
the
d
button to select TO
6.
Using either the
f
or
e
buttons or Numeric buttons select (1)
7. Press
the
d
button to select SWAP.
8. Press
the
f
, the Tv will now place BBC1 into location 1, however the Tv will now display what was inI the
OLD location.
9. Press
the
f
button again to return to the SWAP menu and continue until all the programmes are in the
correct order (BBC1, BBC2, ITV, CH4, ITV5).
To exit the menu press LCD-MENU.
Skip.
When Auto Search is completed there may be unwanted stations seen, these may be noisy or poor pictures from
other signal areas. You cannot delete these, however they may be “hidden” using the SKIP function.
1.
Press the LCD-MENU button 3 times to select the TV Menu
2.
Select CHANNEL and press the
f
or
e
buttons or Numeric buttons select the unwanted channel
3. Press
the
d
button until SKIP text is highlighted.
4. Press
the
f
button to turn SKIP on.
5.
To SKIP other channels repeat 2 to 4.
6.
To Un Skip any channel repeat 2 to 4 as
f
also turns “Skip Off”
You may select any “Skipped” channel using the Numeric buttons.
PC –RGB Operation
.
This TV provides excellent pictures when used as a PC VGA Monitor. Connect the LCD TV to the Computer as
shown on page 8. This connection should be done with both the PC and LCD Tv in the Off state.
Turn on the LCD Tv and PC. Select PC-RGB using the AV/TV button on the Remote control or INPUT button on
the Tv. When the PC has “booted” the display should be bright and clear. If this is not the case, enter the PC Menu
by pressing the Menu button once. Select the “AUTO CONFIG” item and press
f
. The display will shake and
shudder for a few seconds and will then settle to an optimum setting.
If you require other adjustments, re enter the menu and adjust to your requirements.
If you need a sound connection, this should be done whilst the PC and TV are turned off.
Page 12
