Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
Email: [email protected]
Description:
This drum blower is very robustly manufactured and designed for a long service life. It produces a very high air flow
rate with relatively low power consumption. The entire unit and the rotor are made of metal. The blower has two
speed levels, castors and two practical handles. Furthermore, the unit is equipped with an overheating protection
and works with a long-lasting high-performance motor.
Important safety instructions:
-
This drum blower must not be exposed to direct moisture (rain) !
-
Do not operate the unit in environments where there is a risk of coarse dust, dirt or small objects being sucked
in. These could damage the unit or be blown out like projectiles !
-
Never walk with your head/face into the near area of the escaping wind stream, small particles or objects can
be blown out with it, which can lead to injuries !
-
Ensure that the blower stands securely and level !
-
Never use the blower on moving surfaces, objects or vehicles ! There is a risk that the unit may tip over !
-
Supervise the fan when children are near the unit !
-
This appliance is not intended to be used by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and/or knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
-
Never enter or insert objects into the appliance !
-
Never try to touch the moving rotor blades !
-
Do not place any objects on the fan !
-
Do not block the supply and/or exhaust air of the unit and please ensure sufficient space/clearance around the
unit !
-
Ensure that there is sufficient air supply to the unit, otherwise it can lead to a reduction in performance and, in
the worst case, to overheating and/or fire !
-
Only qualified personnel or electricians are allowed to open the unit !
-
Only use the recommended voltage for operating the unit !
-
Make sure that the power cable is unfolded (untied) before connecting it to the socket !
-
Make sure that the plug is cleanly and properly connected to the socket before using the appliance !
-
Never reach near the plug or socket with wet hands !
-
Do not repair defective or damaged cables on the unit yourself, you could get a severe electric shock !
-
Make sure that highly flammable substances (e.g. gases/oils etc.) are never in the vicinity of the unit !
-
If you are not going to use the unit for a long time, switch it off and disconnect the mains plug !
Please switch off the unit immediately and disconnect it from the mains/power supply if anything
seems to be wrong !!! In this case, please contact a specialist and do not try to repair the unit
yourself !!!
Examples:
Fan does not run during operation or fuse has blown.
