MAINTENANCE AND CLEANING INSTRUCTION
Maintenance and cleaning instruction
Please remove the plug from the
socket
before cleaning and maintenance.
·
Do not clean the unit with water.
·
If you are cleaning with scour, please dilute the
scour before use.
·
Do not clean the unit with the solvent listed on the right which may cause distortion
or depigmentation.
·
if clean with chemical solvent,please read its cautions carefully before use.
Cautions
for
the
replacement
of
the
UV
lamp
·
(1) Please turn off power before replacement of filters and UV lamp, otherwise UV
damages eyes or skin when it is working.
Warning
·
Diagram of disassembly
(1) Take off back panel, take out HEPA, activated carbon and photo catalyst filter.
(2) use forefinger
and thumb
hold
the UV lamp, rotate for 90 clockwise or
anticlockwise, then take it out.
Take off cover and filter
Install UV lamp
Installation finished
·
Diagram of installation
(
1
)
Use forefinger and thumb hold the UV lamp, and then put it into UV lamp bracket
rotate for 90 clockwise or anticlockwise, installation finished.
disassembly UV lamp
Alkalescence
Benzene
Acohol
Scour
Decontamination
power
9
F A Q
Please kindly check as below before you send out for repair
.
Abnormality
Inspection items
Does not work
·
Check if the plug has disconnected from the socket
.
Connect the power again
.
·
Check if the front panel is installed completely
.
Recover the front panel carefully
.
Continuously working
and can not stop.
The LED is in red all
the time
The dirt in the air
is not removed
and it is noisy
·
It maybe because of IC interference.
Unplug
the
power
and
restart
the unit after
·
Clean the HEPA filter or replace with a new one.
If the problem still exist after the above inspection,please
disconnect the power and send for repair.
15 minutes later.
HEPA filter is dirty.
10