Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
Email: [email protected]
6. Now put the rubber plug back on the drain hole and finally screw the cap back on properly.
7. Finally, you can switch the mobile air conditioner on again and the signal light "Condensation tank is full" (K) on
the control panel should now go out.
If you want to operate the air conditioner without the condensation tank, please take the following steps:
1. Unscrew the cap and then remove the rubber stopper by pulling it out horizontally. Keep both cap parts in a
safe place for later use.
2. Connect the plastic hose supplied to the condensation drain hole and lead off the other end so that there is a
slope and the condensation can drain off easily/unhindered (see fig. below).
3. The drain hose can be extended or also replaced. In this case, please use a suitable hose. A ¾ inch hose is
best suited/fitting.
Maintenance:
Always disconnect the mains plug before cleaning your air conditioner !
To keep the effectiveness and service life of your air conditioner high, please clean this unit regularly !
Cleaning the housing:
Use a soft and damp cloth to clean the housing of the air conditioner. Please do not use aggressive cleaning
agents, they may damage your unit !
Cleaning the filters (does not apply to the activated carbon filter net):
Use a hoover to clean the filters or tap them out gently.
Alternatively, you can rinse the filters under running water. Please make sure that the water is no hotter than 40°C.
Allow the filters to dry completely before putting them back into the appliance !
Note: Please never operate the air conditioner without a filter !
