5
i. Set the rotary switch at Hz.
j. Press the trigger to open the jaw and fully enclose the conductor to be
measured. If line frequency is to be measured, enclose only one line of the
line source and make sure there is current flowing.
k. Read the Hz value from the LCD display.
3.3 Relative Reading Measurements
The zero button also can be used to make a relative measurement. Once the
button is pushed, the current reading is set to zero and a zero symbol shall be
displayed on LCD. All the subsequent measurement shall be displayed as a
relative value with respect to the value being zeroed. Press the zero button for
2 seconds to return to normal mode. Zero/Relative function will be disabled, if
MAX/MIN function is enabled.
3.4 Holding the LCD Reading
Press the HOLD button, then the reading shall be hold and kept on LCD.
3.5 Finding the MAX/MIN Value
Press the MAX/MIN button to enable the maximum and minimum values to be
recorded and updated during measurement. Push the button once, the
maximum value shall be displayed and updated.. Push again (second push),
the minimum value shall be displayed. Push again (third push), MAX/MIN
function shall be disabled and return to the normal measurement mode.
Zero/Relative function will be disabled, if MAX/MIN function is enabled.
www.tmatlantic.com
