18
MAINTENANCE
Checking Spark Plug
•
Remove cap. Then remove spark plug cap.
•
Disconnect the spark plug wire from the spark plug.
•
Before removing the spark plug, clean the area around its base to prevent debris from
entering the engine.
•
Insert a spark plug socket wrench through the opening on the outside of the cover. Turn
the wrench counterclockwise.
•
Check for discoloration and clean carbon deposits off the electrode with a wire brush.
•
Check the electrode gap and slowly adjust to 0.6 - 0.7mm (0.024-0.028 in) if necessary.
•
Reinstall spark plug and tighten to Torque 20.0Nm (14.8ft-lb).
•
If spark plug is worn replace only with an equivalent replacement part. Spark plug
should be replaced annually.
•
Reconnect spark plug wire.
•
Replace spark plug cap, then replace cap.
Standard Spark Plug:
E6TC/E6RT/BPR6HS
Spark Plug Gap:
0.6 - 0.7mm (0.024-0.028 in)
Spark Plug Torque:
20.0Nm (14.8ft-lb)
Carburetor Adjustment
The carburetor is low emission and is equipped with a non-adjustable idle mixture valve. If adjustment is needed contact an
authorized dealer.
0.6
-
0.7mm
