8
Charging the Battery
CAUTION!
Using an unapproved charger or batteries may cause a fire and result in
minor or moderate injuries. Always use an approved charger provided by
Akron Brass to charge batteries.
Immersing the battery or charger in liquid may result in minor or moderate
injuries. Never immerse the battery or charger in liquid.
Low Battery Warning
When the Revel Scout is powered on and the battery is
low, the light will flash to indicate a low battery condition.
It will flash quickly four times, pause for 30 seconds and
flash another four times. After the second set of flashes it
will adjust the brightness to the medium setting to
conserve battery and extend runtime. It will continue to
flash every 30 seconds until a new battery is installed or
the battery discharges and the light turns OFF.
To charge the battery:
1.
Connect the charger to a power source.
2.
Place the battery in the charger.
Optional Charger Installation
The charger can be mounted to a horizontal surface.
Follow these steps to install the charger:
1.
Position the charger in the desired location.
2.
Attach the mounting hardware to the bottom of the charger.
3.
Attach the charger to a horizontal surface using the mounting hardware.
Solid Red:
Power On
Blinking Red:
Stop: Charger Fault
Solid Green:
Battery Charging
Blinking Green:
Battery Fully Charged
Solid Red:
Battery Fault
Blinking Red:
Temperature Out of Range
The Status Lights will indicate the following:
