W I R E B I N D I N G
1.
1. Insert pre-selected wire into
Wire Holder.
2. Insert document from last
pages to first pages then
insert front cover. The back
cover should be inserted
last with inside facing up.
3. Take out inserted document
from
Wire Holder
to close
the wire.
A. Put inserted document into
Wire Closer
.
B. The wire element must stand horizontally at the bottom of
Wire Closer
.
C. Pull
Closer Handle
forward to close.
D. Take out document and turn back cover over. The Wire binding is completed.
C O M B B I N D I N G
a.
c.
S
2
I
0
O
9
0
J
C
PR
O
E
T
2.
r n
F o t
v r
Co e
ack
B
Cover
3.
Back
Cover
7
"
"
7
"
"
3. Neatly align the pages and covers. Holding the
documents tightly with the front towards you, feed the
comb through the holes.
4. When all combs are fully positioned through the holes,
slowly move handle backward to close the comb. Lift out
the bound documents from fingers. The comb binding is
complete.
b.
1.
2.
3.
4.
1. Place pre-selected comb
behind Comb Binding
Fingers. The comb
opening side should be
upward.
2. Slowly pull Comb Binding
Handle forward to open
comb until the comb
binder is opened
sufficiently to allow pages
and covers to be inserted.
o
Fr
nt
ove
C
r
B
c
a
k
ov
C
er
P
:1
:
3
1
INSERTING
CLOSING
d.
C O I L B I N D I N G
1.
3.
2.
1. Align punched document and place document on top of table. Insert the coil into the first 4 to 5 holes.
2. Hold document evenly and slide hand to drive the coils forward to insert into the holes.
3. Use crimpers to cut & crimp the excess coil. Make sure you crimp-in both ends. This procedure will prevent the
document from unbinding itself.
– Optional, for efficient Coil Binding, use Roll@Coil for electric binding if you have heavy and frequent jobs by
Coils binding.
