is placed onto the bottom of base ring. Install
3
Open the valve, then turn the handle according to the
sign of C and H on the handle to regulate the temperature
of the water. (C=Cold,H=Hot)
.
6
Close
Open
Swing Spout
7
After installation is complete, remove aerator and rotate
handle to the closed position. Then turn on the water supply
valves, and check all connections for a leak. Turn on
your faucet and allow both hot and cold water to run at
least one minute each, then Install the Aerator.
Faucet Start Up
INSTALLATION PROCEDURES
You should clean all the dirts from valve outlets.
Turning off the water supply valves. This is usually
found near the water meter. If you are replacing
an existing faucet, remove the faucet from the
sink and clean the sink surface thoroughly.
Install without deck plate. Make sure the O-ring
faucet through hole in sink. From underside sink,
put Plastic Washer and mounting nut. Position
faucet on sink properly and tighten mounting nut.
If necessary, tighten screws using a adjustable
wrench until the faucet is firmly connected to the
sink.
Connect the hot and cold water supply lines of the faucet
to the water supply valves.
2
1
2
3
5
4A
Install with deck plate. Place a bead of plumber’s
putty between faucet and sink. Place deck plate
over the three holes of sink.
2A
Make sure the O-ring is placed onto the bottom
of base ring. Install faucet through deck plate.
From underside sink, put plastic washer and
mounting nut. Position faucet on sink properly
and tighten mounting nut.
2B
Insert spray seat through far right-hand hole on sink,
then tighten mounting nut using adjustable wrench.
Insert spray hose down through spray seat, then connect
the spray hose to the outlet hose at the bottom of the tap
and tighten it.
4B
If you do not want to install the spray, please use the plug
"L" to block-off and tighten it.
If you do not want to install the spray.
Install side spray.
Pipe plug
