Refer to Table 5.
Table 5: Jumper posi-
tions for activating and
deactivating the bass
cut filter.
4.6 Deactivating the
Microphone Muting
Function
Refer to fig. 8.
Fig. 9: Microphone
muting function ON (a)
and OFF (b).
Refer to fig. 9.
Refer to fig. 8.
5.1 Headphones,
Microphone,
Connecting Cable
Important!
5.2 W 44, W HSD
Windscreens
Important!
•
To deactivate the bass cut filter, place the jumper (3) on any two con-
tact pins (4) as per Table 5 below.
6. Push the pcb into the shell, replace and tighten the fixing screw (1),
and screw the cable bushing (2) onto the blue strain relief (5).
1. Disconnect the phantom power adapter from the mixer input.
2. Remove the fixing screw (1) from the phantom power adapter.
2. Unscrew the cable bushing (2).
4. Pull the pcb out of the shell WITH EXTRA CARE.
5. Unsolder the green wire from the pcb and insulate the stripped end
with insulating tape.
6. Push the pcb into the shell, replace and tighten the fixing screw (1),
and screw the cable bushing (2) onto the blue strain relief (5).
1. Disconnect the headphone and microphone cables from the mixer.
2. Use a cloth moistened (not wet!) with water to clean the surfaces of
the equipment.
•
Never use caustic or scouring cleaners or cleaning agents con-
taining alcohol or solvents since these may damage the enam-
el or plastic parts.
1. Remove the windscreen from the microphone.
•
To avoid damaging the windscreen fixed on the microphone, be
extremely careful in removing the W HSD from the HSD 171/271/271
Single microphone!
4 Operating Notes
18
HSC 171/271, HSD 171/271/Single
Bass cut filter ON
Bass cut filter OFF
5 Cleaning
a
b
