14
DMSTetrad
Setting
up
The provided transmitter is preconfigured to channel 1 on the receiver.
Use the identification feature to check
the channel on the receiver assigned for a transmitter
and
the connected transmitter for a channel on the receiver.
Briefly press
Connect (18)
on the transmitter or receiver.
The
Status
LEDs (15)
on the same channel of the transmitter and receiver flash
green.
NOTE
This identification feature can also be used during operation without causing any disturbance or
interruption.
The following instructions apply for the assignment of a free channel and for changing a channel.
Actions 3 and 4 can be started from the transmitter and receiver. In this example, they are
started from the receiver.
1)
Pull the
battery compartment cover (16 / 24)
down and off the transmitter.
2)
Switch on the transmitter and receiver.
3)
Press
Connect (3)
on a free channel of the receiver and hold down until the
Status LED (5)
starts to flash after approximately 2 seconds.
You need to confirm with the transmitter within the next 30 seconds.
4)
Hold down
Connect (18)
on the transmitter until the
Status LED (15)
lights up green.
The status LEDs on the transmitter (15) and the receiver (5) light up green once
assignment has been successful.
NOTE
The actuated settings are saved. This means that you can simply continue using the DMSTetrad
system with the last-used settings (channel assignments) the next time you switch on.
NOTE
Duplicate channel assignment
is not possible with the DMSTetrad system!
This means that you cannot assign two (or more) transmitters to one channel on the receiver.
The LED of the connected transmitter is lit green; the LED of the transmitter that is not connected
flashes green. Please assign a free channel to this transmitter.
Make sure you do not assign the same channel twice!
Start the registration process with the
transmitter
: Transmitter -> Receiver
1)
Pull the
battery compartment cover (16 / 24)
down and off the transmitter.
2)
Switch on the receiver.
3)
Press and hold
Connect (18)
on the transmitter while pressing the
On/Off button (17)
until
the
Status LED (15)
starts to flash.
Within the next 30 seconds, the status LED (15) flashes rapidly and you need to
confirm with the receiver.
4)
Hold down
Connect (3)
on a free channel of the receiver until the
Status LED (5)
lights up
green.
The status LEDs on the transmitter (15) and the receiver (5) light up green after
successful registration.
Identifying the channel and/or appliance
Assign the transmitter to a free channel or
change the channel
Registering a new transmitter on the
receiver
