seconds and a control tone will be heard.
Pairing
When starting the system, the
Bluetooth Accessory Adapter
will automa-
ticall go into the pairing mode (LED blink alternately blue and red).
Pairings that are not needed could slow down the Bluetooth connection, we
therefore recommend to erase them. To do so, shortly press the operating
button twice when in pairing mode. A short switching of LEDs and a control
tone indicate that all pairings are now erased.
Please note: At many Bluetooth devices deleted entries are really erased only
after turning off the device.
You can now start with the new pairing.
Please hold both Bluetooth devices close together and
make sure that no other Bluetooth system
close to you is switched on while pairing!
If your Bluetooth device does not automatically find the
Bluetooth
Accessory Adapter
, have it search for audio or Bluetooth equipment.
Repeat, if necessary.
Please confirm, after your Bluetooth system has found the adaper. In case that
you are asked for a password, just put in 0 0 0 0. Now your Bluetooth system
will make a connection. If no connection is made after pairing, it is recom-
mended to turn the device off and on again by using the operating device.
The
Bluetooth Accessory Adapter
will be registered as headset. If you have a
connection, you will get a headset icon on most Bluetooth devices.
Connect automatically with the AKE “Pair and Go” system
In order to automatically get the Bluetooth connection, you have to get the
authorization for the
Bluetooth Accessory Adapter
at your Bluetooth
equipment, pl
Bluetooth Accessory Adapter
ease refer to the manual of your Bluetooth device (for devices with
A2DP only, this is most likely not possible).
First turn on your Bluetooth equipment
before activating your
.
With the
Pair and Go
- Bluetooth technology from AKE
the devices, once paired, will automatically get connected.
The active connection is indicated by the blinking blue LED. When in A2DP
mode, the blue LED flashes twice.
12
ENGLISH
Re-pairing and Multipoint
To pair another device with Bluetooth interface or for a re-pairing, please refer
to “procedure for first start-up / pairing”.
The
Bluetooth Accessory Adapter
supports the
Operation is possible either with the operating key on the
Bluetooth
Accessory Adapter
or by pressing the Enter key at the
PowerCom
operating device.
Basic functions of the AKE Bluetooth-Accessory-Adapter
Automatic switch-on, searching and pairing:
After starting the vehicle
on-board power the Bluetooth Accessory Adapter
If there is no Bluetooth partner, it will automatically go into pairing mode.
Manual switch-on:
Press operating key for 2 sec.
Manual switch-off:
Press operating key for 8 sec.
Volume adjustment:
For each paired device you can individually adjust the basic volume. At
activated audio connection shortly press operating key for higher volume or
lower volume, double click reverses the setting direction (control beep: 5 x
short high). If the volume can not be adjusted during navigation message,
you can also use every mobile phone connection for this.
Adjust the volume according to your request while standing. When using at a
PowerCom
system, this
takes
care
of
the
adjustements
according
to
the
driving
noises.
A single click in pairing mode activates or deactivates automatic answering (control
sounds. A short ringtone signals the change (Release 2: Two short high beep).
®
Multipint feature from
®
CSR . Therefore it is possible that two paired and Multipoint-compatible
devices can be operated on the same Accessory Adapter at the same time.
Attention, not all devices support this mode.
will after approx. 30 sec.*
automatically be in ready-to-operate status and will search for the Bluetooth
partner.
Activate/deactivate automatic answer:
13
Operating key
LED indicator
Connector
*) Prevents error when re connecting after power interruptions.
ENGLISH
