Reset or use with other devices
When encountering inexplicable malfunctions or if used with not yet
paired Bluetooth helmet sets, you will have to pair the devices again. If
not, you can ignore the following two chapters.
If the
pocket repeater was paired already, it will search
for his partner when switched on (green LED flashes in 1-second
pulse). Now wait for approx. 15 sec. until the green LED is flashing
slowlier and than switch-off the desired cannel of the
pocket repeater (press the respective button until the red LED goes on).
Hold your Bluetooth helmet or helmet set close to the connected
pocket repeater and make sure that no other Bluetooth
device in the area is ready for pairing.
Now get the Bluetooth helmet (set) ready for pairing by activating the
device and holding down the button until the LEDs flash alternately
(refer to the operating instructions of the Bluetooth helmet set).
Now also activate the pairing mode at the
repeater (press the respective button and hold down until the LEDs flash
alternately).
After a successful pairing, the LED will slowly flash green (standby
mode).
Depending on the Bluetooth components used, the connection is only
on stand by and has to be activated in different ways after the pairing
or when restarting.
Shortly press button on Bluetooth Helmet Connector after pairing
and wait until green LED is permanently on
The pairing
Activating the connection
BlueCom 102
BlueCom 102
BlueCom 102
BlueCom 102
Bluetooth Helmet Set 101
•
AKE
ENGLISH
12
