Requirements
The AKE “Plug & Play” service
1. An already charged
pocket repeater.
2. One or two Bluetooth helmets or an adequate Bluetooth system
with charged battery that works with the headset protocol, pass
word where required: 0000, 1111 or 1234
3. All Bluetooth components must be within the reach of the
Bluetooth connection (max. 10 m). If the
repeater is positioned in the center, the range will be doubled, as
always with repeaters.
Please note that due to shadowing effects or interferences it is possible
that the range is considerably reduced and also, that the volume is
layed out for driving noises and therefore disturbing noises like an
occasionally arising plopp might not be avoidable when in standby.
For an optimum connection the pocket repeater should not be kept
closer than 50 cm to the Bluetooth helmset (lower jacket pocket).
When you purchase the Pair and Go
pocket repeater
and the Bluetooth helmet sets together, they are ready to be used
immediately. The
pocket repeater will read on the back
“
”. To avoid confusions,
you should mark your helmet with the attached labels.
BlueCom 102
BlueCom 102
BlueCom 102
BlueCom 102
Paired with AKE Bluetooth Helmet Set ...
First start the Bluetooth helmet set and put on the helmet.
Then switch on the BlueCom 102 pocket repeater
and off you go.¹
11
ENGLISH
¹) Please mind correct order and wait for the automatic connection. The green LED
changes from flashing to status on. If the green LED is on, but no signal is heard,
press button at helmet set, if control melody is heard but however no signal, press
button once more.
