9
Vent Cover Bracket Installation
5. Mark the hole location.
6. Attach chimney mounting bracket to the wall by using
two M5 x 12
screws.
A. Central point
B. M5 x 12 screw
C. Chimney mounting bracket
Complete Preparation
1. Determine and make all necessary cuts in the wall for the vent system. Install the vent system
before installing the hood. See “Venting Requirements” section.
2. Determine the required height for the home power supply cable and drill a 1¼" (3.2 cm) hole at
this location.
3. Run the home power supply cable according to the National Electrical Code or CSA Standards
and local codes and ordinances. There must be enough ½" conduit and wires from the fused
disconnect (or circuit breaker) box to make the connection in the hood’s electrical terminal box.
NOTE: Do not reconnect power until installation is complete.
4. Use caulk to seal all openings.