Akaso TC05, User Manual

Page: 6 / 12

4. Video Resolution:
1920 x 1080P@25FPS / 1280 x 720P@25FPS / 720 x 480P@25FPS /
640 x 480P@25FPS / 320 x 240P@25FPS
Videos are recorded in AVI format which can be played back on most video devices.
5. Video length:
Default 5 seconds, optional 3s-59s, 1min-10mins.
6. Audio recording:
On / Off.
7. Shot lag:
Default 1 Min. Optional 5 seconds to 60 minutes.
If the shot lag is short, the camera shooting frequency would be high. There would be
high consumption of the power. It would affect the usage days of the batteries.
8. Side Motion sensors
During the alignment consider whether the use of the side motion sensors may be useful
for attaining the desired observation results or not.
9. Sensitivity of motion sensors:
High / Medium / Low
Choose “ High ” for interior places with little interference.
Choose “
Medium
” for exterior places with a normal amount of interference.
Choose “ Low ” for places with a high level of interference.
10. Target recording time
You can set the starting working time and ending time according to your demand. Once
setting, your trail camera will only work within the setting time everyday.
11. Time lapse
You can set the time interval by choosing Hr, Min and Sec. The camera would take pictures
automatically in every set time intervals.
12. Language: English / Français / Deutsch / Español / Italiano /
日本語
/
简体中文
13. Time & Date
Time format: 12/24hr
Date format: dd/mm/yyyy, yyyy/mm/dd, mm/dd/yyyy
14. Photo stamp
You can choose to turn on/turn off the watermark of your photo as you like.
15. Password protection
Press
MENU
to find Select “
Password protections
”. Press “
OK
”, then select “
ON
” to set the
password of the camera. The password is a 4-digit number selected between 0-9. If the
password is lost, press keys of
MENU
and
REPLAY
at the same time, and slide the
operating mode selector switch from OFF to SETUP position. The camera is unlocked.
16. Beep sound
It depends on you to turn on or turn off the beep sound.
17. Format memory card
We suggest to format the micro SD card first in this trail camera before using. To keep
your micro SD card in good condition, reformat it on a regular basis. Reformatting erases
all of your content, so be sure to offload your photos and videos first.
18. Serial No.
Press “
MENU
” to find “
Serial numbers
”. Press “
OK
”, then select “
ON
” to set the serial
number for the camera. The serial number is a 4-digit number selected between 0-9.
19. Reset settings
Rest the camera to the default settings. You need to set date and time again.
20. Version
Select to check the camera’s current firmware version number.
21. Playback
Take down the camera from where it’s fixed. Slide the operating mode selector switch to
the “
SETUP ” position. Press REPLAY key and Up/Down key to review the photos/videos.
While reviewing photos, press
Up/Down
key to page
Up/Down
. While reviewing videos,
press OK key to start playing, press OK to pause, press MENU one more time to Stop.
Press
REPLAY
key to return into standby.
7 8