If a fault occurs, first check the points listed below before taking the unit for repair. If you are unale to remedy a
problem by following these hints, consult your dealer or service center.
WARNING: Under no circumstances should you try to repair the unit yourself, as this would invalidate the
guarantee.
IMPORTANT: Due to continual revision and improvement on our product design,
specifications are subject to change without further notice.
Power Supply
AC120V~60Hz
DC 9V (LR14-1.5V x 6 pieces)
Dimensions (H x W x D)
10.7” x 5.2” x 7.6”
Net Weight
3.0 lb (1.3 kg)
Radio Section
Frequency Coverage
FM: 87.5 - 108 MHz ; AM: 520 - 1710 kHz
Power Output
1.2 W x 2 (RMS)
Speaker Impedance
8 Ohms
PROBLEM
POSSIBLE CAUSE
REMEDY
Noise or sound distorted on
AM or FM broadcast
- Station not tuned properly
for AM or FM.
- FM: FM telescopic antenna
is not extended.
- AM: The bar antenna is not
positioned correctly
- Retune the AM or FM
broadcast station.
- FM: Extend FM telescopic
antenna.
- AM: Reposition the unit until
the best reception is
obtained.
AM or FM no sound
- Unit not in “RADIO” function
mode.
- Volume set at minimum
- Press FUNCTION button to
switch the unit to FM or AM
radio mode.
- Increase Volume.
CD player does not play
- Unit not in CD function
mode.
- CD is not loaded properly.
- If the CD is self-compiled,
the media used may not be
compatible with the player.
- Press FUNCTION button to
switch the unit to CD Mode.
- Load CD with label side up.
- Use better quality blank
media and retest.
CD skips while playing
- Disc is dirty or scratched.
- Wipe CD with clean cloth or
use another disc.
Intermittent sound from
CD player
- Dirty or defective disc
- Dirty pick up lens
- Player is subject to
excessive shock or vibration
- Clean or replace the
defective disc.
- Use a CD lens cleaning disc
to clean the lens.
- Relocate the player away
from shock or vibration.
EN - 11
TROUBLESHOOTING
TECHNICAL SPECIFICATOIN