4
ASSEMBLING
1. Unscrew the spinner clockwise and the nut counter-clockwise then remove both
of them
2. Use “Base Screw” to screw “Base & Fan Pillar” tightly, and then cover the “Base
Cover”
3. Install” Rear Guard” in proper position with handle up and screw the screw.
4. Screw on plastic nut tightly to attach rear guard
5. Set the “Rear Guard” into the “Round ring” in the proper position
6. Install “Fan Blades” into “Blade Holder” in the proper position and then fix onto
motor shaft
7. Cover “Blade Holder Cover”
8. Screw “Spinner” on to motor shaft counter-clockwise, to prevent the spinner can
be removed by hand, please screw the screw at the centre of “Spinner”, then put
the rubber protector to cover the screw carefully.
9. Fix “Front Guard” into “Round Ring” in the proper position
OPERATING
Place the appliance on a dry and flat surface. Operate the appliance with the noted
power voltage which was marked on the appliance (A.C. only). Do not immerse the
appliance into water; use a damp cloth to wipe the body and a dry one to wipe over
the water. Note: please let the appliance cool down fully before cleaning.
1. Plug the power supply cord into
a wall outlet.
2. To make/stop the fan head
oscillate, pushes down/pull the
clutch knob.
3. To adjust the airflow upward or
mild downward, simply adjust
the grille to desired angle by
hand freely, must shut down
the fan before the adjustment.
4.
Speed is controlled by Speed
switch.
Distributed by Tempo (Aust) Pty Ltd
ABN 70 106 100 252
Unit 8/14 Rodborough Rd, Frenchs Forest, Australia NSW 2086
Customer Help Line : 1300 886 649 (AU) | 0800 836 761 (NZ)
Telephone:
(02) 9975 2199 Fax: (02) 9975 2688
Email:
OPERATION
Place the appliance on a dry and flat surface. Operate the appliance with the noted
power voltage which was marked on the appliance (A.C. only). Do not immerse the
appliance into water; use a damp cloth to wipe the body and a dry one to wipe over
the water. Note: please let the appliance cool down fully before cleaning.
MAINTENANCE
Before carrying out routine cleaning, switch off the fan and disconnect mains power.
Use a soft, damp cloth only and do not use abrasive substances.
NOTE:
Do not submerge any part of the fan in the water.
1. Plug the power supply cord into a
wall outlet.
2. To make/stop the fan head oscillate,
pushes down/pull the clutch knob.
3. To adjust the airflow upward or mild
downward, simply adjust the grille
to desired angle by hand freely,
must shut down the fan before the
adjustment.
4. Speed is controlled by Speed switch.
RECYCLING
At the end of its working life, do not throw this appliance out with your household
rubbish. Observe any local regulations regarding the disposal of electrical consum-
er goods and dispose of it appropriately for recycling. Contact your local authorities
for advice on recycling facilities in your area.
